INFCP
TABLE OF CONTENTS

Part 1: Introduction
1.1	Unpacking
1.2	Safety Considerations

Part 2: About the Meter
2.1	Description
2.2	Features
2.3	Available Accessories
2.4	Front of the Meter
2.5	Back of the Meter
2.6	Disassembly

Part 3: Getting Started
3.1	Rating/Product Label
3.2	Main Board Power Jumpers
3.3	Panel Mounting
3.4	Connecting Sensor Input
3.5	Connecting Main Power
3.6	Connecting External Tare Switch
3.7	Connecting Analog and Relay Output

Part 4: Configuring the Meter
4.1	Selecting the Input Type
4.2	Selecting a Decimal Point Position
4.3	Selecting Reading Scale and Offset
4.3.1	Scaling with Known Loads
4.3.2	Scaling without Known Loads
4.4	Using Reading Configuration
4.4.1	Enabling or Disabling the Front-Panel Tare
4.4.2	Setting Input Resolution
4.4.3	Displaying the Filtered/Unfiltered Input Signal
4.5	Using Setpoint 1 Configuration
4.5.1	Setting Setpoint 1's Active Band
4.5.2	Selecting if Setpoint 1 is Latched or Unlatched
4.6	Using Setpoint 2 Configuration
4.6.1	Setting Setpoint 2's Active Band
4.6.2	Selecting if Setpoint 2 is Latched or Unlatched
4.7	Setting the Setpoint 1 Deadband
4.8	Setting the Setpoint 2 Deadband
4.9	Using Output Configuration
4.9.1	Enabling or Disabling the Analog Output
4.9.2	Selecting Analog Output as Current or Voltage
4.9.3	Selecting Analog Output or Proportional Control
4.10	Selecting Proportional Band
4.11	Using Manual Reset
4.12	Using Output Scale and Offset
4.13	Using Lock Out Configuration
4.13.1	Enabling or Disabling the RESET Button in the Run Mode
4.13.2	Enabling or Disabling Setpoint Changes
4.13.3	SETPTS Display Function: Software Vers./ Setpoint value

Parts 5, 6, 7, 8, 9
5	DISPLAY MESSAGES
6	MENU CONFIGURATION
7	SETPOINT CONFIGURATION DISPLAYS
8	SPECIFICATIONS
9	FACTORY PRESET VALUES
WARRANTY / DISCLAIMER
NOTES, WARNINGS AND CAUTIONS Information that is especially important to note is identified by three labels: NOTE WARNING CAUTION IMPORTANT Note: provides you with information that is important to successfully setup and use the Programmable Digital Meter. CAUTION or WARNING: tells you about the risk of electric shock. CAUTION, WARNING or IMPORTANT: tells you of circumstances or practices that can effect the meter's functionality and must refer to accompanying documents.